fireballglass02
fireballglass03
fireballglass04
fireballglass05
fireballglass06
fireballglass07
fireballglass08
fireballglass09
fireballglass10
fireballglass11
fireballglass12
fireballglass13
fireballglass14
fireballglass15
fireballglass16
fireballglass17
fireballglass18

Fireball Backglass

$269.00 USD

New 2019+ stock – perfect multi-layer Digtial Prints, made-to-order.  Genuine tempered glass (not a translite). This particular glass is made on a heavier 4mm (thicker) panel.  Beyond a replacement, perfect as a wall hanging in your gameroom, this glass is relevant all on its own. Polished corners and edges, ready for new trim and lift bar (or use your old ones).  Turnkey replacement, finally get rid of that old chipped, crackled, or shedding original backglass.

SKU: GLAS-Fireball Category:

REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS

  • Never “triple thick” or apply any additional coatings to the backside of the glass.
  • Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
  • If laying a glass down on its backside, always put down a towel or fabric to lay on.
  • The glass stock is tempered – so avoid significant hot-cold temperature shifts.
  • Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
  • Never allow ‘sitting’ moisture on the backside.  After 5-7 minutes there is a risk of ink degradation.
  • Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
  • If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
  • After wiping, make sure the liquid is dried off (wipe all the way to dry).  Do not allow any moisture to sit.
  • Glass cleaner sprayed directly on the fronts is fine.
  • Don’t let cleaner sit between the channels and your glass.