Pinbot Custom Backglass (Mirrored)

Please Note: This is NOT a “reproduction backglass” – it is a completely “new” Pin*Bot creation.
It is not meant to be compared to the original translite. Rather, it is meant to completely replace it.
This is our vision of what a “real” Pin*Bot backglass might have been, had the machine historically had one.
This is a genuine tempered-glass backglass, containing original artwork taken from the translite,
with custom mirroring added.

REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS

• Never “triple thick” or apply any additional coatings to the backside of the glass.
  
• Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
  
• If laying a glass down on its backside, always put down a towel or fabric to lay on.
  
• The glass stock is tempered – so avoid significant hot-cold temperature shifts.
  
• Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
  
• Never allow ‘sitting’ moisture on the backside.  After 5-7 minutes there is a risk of ink degradation.
  
• Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
  
• If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
  
• After wiping, make sure the liquid is dried off (wipe all the way to dry).  Do not allow any moisture to sit.
  
• Glass cleaner sprayed directly on the fronts is fine.
• Don’t let cleaner sit between the channels and your glass.