Eight Ball Custom Backglass (Mirrored)

$269.00 USD

The classic Eight Ball backglass, with a twist…  This is a new CPR custom mirrored version of the glass, on which our Art Director has added tasteful mirror bits.  Add a little traditional pinball glitz to your machine, where Bally had omitted mirroring on this game’s backglass!   This is our vision of what the Eight Ball backglass could/should have been. You can check out the photo gallery for identification of the custom mirrored areas.

There are certainly traditionalists who don’t want to make changes to the original look.  Have no fear – we offer this glass in a NON-mirrored version as well.  Go back to the Backglass section of the Store and select the Standard version.  OR CLICK HERE

Reproduction backglass produced on genuine tempered glass. Polished corners and edges. Silkscreened ink-mirroring.

Exempt from our liftbar & trim kit availability, due to being pre-1980 3/16″ (or 5mm) thickness –  too thick to fit our CPR custom trim

Gorgeous replacement, finally get rid of that old chipped, crackled, or shedding original backglass.

SKU: GLAS-EBALL-MIRRORED Category:

REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS

  • Never “triple thick” or apply any additional coatings to the backside of the glass.
  • Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
  • If laying a glass down on its backside, always put down a towel or fabric to lay on.
  • The glass stock is tempered – so avoid significant hot-cold temperature shifts.
  • Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
  • Never allow ‘sitting’ moisture on the backside.  After 5-7 minutes there is a risk of ink degradation.
  • Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
  • If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
  • After wiping, make sure the liquid is dried off (wipe all the way to dry).  Do not allow any moisture to sit.
  • Glass cleaner sprayed directly on the fronts is fine.
  • Don’t let cleaner sit between the channels and your glass.