Solar Fire Backglass
$289.00 USD – $315.00 USD
Reproduction backglass produced on genuine tempered glass. Polished corners and edges. Silkscreened ink-mirroring.
Includes a custom made CPR-matched-thickness stainless steel liftbar & trim kit, by default – OR you may pick from a selection of powder-coated liftbar color choices.
Gorgeous replacement, finally get rid of that old chipped, crackled, or shedding original backglass.
REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS
- Never “triple thick” or apply any additional coatings to the backside of the glass.
- Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
- If laying a glass down on its backside, always put down a towel or fabric to lay on.
- The glass stock is tempered – so avoid significant hot-cold temperature shifts.
- Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
- Never allow ‘sitting’ moisture on the backside. After 5-7 minutes there is a risk of ink degradation.
- Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
- If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
- After wiping, make sure the liquid is dried off (wipe all the way to dry). Do not allow any moisture to sit.
- Glass cleaner sprayed directly on the fronts is fine.
- Don’t let cleaner sit between the channels and your glass.
Care Instructions
REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS
- Never “triple thick” or apply any additional coatings to the backside of the glass.
- Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
- If laying a glass down on its backside, always put down a towel or fabric to lay on.
- The glass stock is tempered – so avoid significant hot-cold temperature shifts.
- Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
- Never allow ‘sitting’ moisture on the backside. After 5-7 minutes there is a risk of ink degradation.
- Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
- If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
- After wiping, make sure the liquid is dried off (wipe all the way to dry). Do not allow any moisture to sit.
- Glass cleaner sprayed directly on the fronts is fine.
- Don’t let cleaner sit between the channels and your glass.
US Tarriff Info
*Important info when purchasing Lift Bar Kits*
The liftbars are all made to the most common backglass width of 28.5 inches, just like they have been sold for decades in the hobby. IF you have a backglass that is of lesser width, the end-user is expected to cut/chop to the lesser length needed.
PLEASE NOTE: These are for 1/8″ -or- 4mm (metric) backglasses. Sorry, these will not fit on “thick style” 3/16″ or 5mm backglasses, either original or CPR repro (roughly any glass for a game 1979 or prior). We do not offer 3/16″ style liftbars at this time.