Supersonic Custom Mirrored Backglass

$289.00 USD – $315.00 USD

Custom mirror bits added in tasteful places to the original artwork layout. See gallery diagram to see exactly where the mirror bits were added.

Reproduction backglass produced on genuine tempered glass. Polished corners and edges. Silkscreened ink-mirroring.

Includes a custom made CPR-matched-thickness stainless steel liftbar & trim kit, by default – OR you may pick from a selection of powder-coated liftbar color choices.

Gorgeous replacement, finally get rid of that old chipped, crackled, or shedding original backglass.

SKU: GLAS-SUPERSONIC Category:

REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS

  • Never “triple thick” or apply any additional coatings to the backside of the glass.
  • Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
  • If laying a glass down on its backside, always put down a towel or fabric to lay on.
  • The glass stock is tempered – so avoid significant hot-cold temperature shifts.
  • Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
  • Never allow ‘sitting’ moisture on the backside.  After 5-7 minutes there is a risk of ink degradation.
  • Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
  • If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
  • After wiping, make sure the liquid is dried off (wipe all the way to dry).  Do not allow any moisture to sit.
  • Glass cleaner sprayed directly on the fronts is fine.
  • Don’t let cleaner sit between the channels and your glass.