Xenon Backglass

$289.00 USD – $315.00 USD

Reproduction backglass produced on genuine tempered glass. Polished corners and edges. Silkscreened ink-mirroring.

Includes a custom made CPR-matched-thickness stainless steel liftbar & trim kit, by default – OR you may pick from a selection of powder-coated liftbar color choices.

Gorgeous replacement, finally get rid of that old chipped, crackled, or shedding original backglass.

SKU: GLAS-XENON Category:

REPRODUCTION BACKGLASS CARE and RECOMMENDATIONS

  • Never “triple thick” or apply any additional coatings to the backside of the glass.
  • Alcohol, acetone, and most ‘rattle-can’ liquids must NEVER contact with the ink.
  • If laying a glass down on its backside, always put down a towel or fabric to lay on.
  • The glass stock is tempered – so avoid significant hot-cold temperature shifts.
  • Be cautious of any impacts to the edges, such as setting the glass down on a concrete floor.
  • Never allow ‘sitting’ moisture on the backside.  After 5-7 minutes there is a risk of ink degradation.
  • Do not spray cleaner directly onto the backside as prolonged contact with liquids may damage your glass.
  • If you must clean the backside (bulb dirt, etc.) wipe with a pre-dampened cloth (water or Windex).
  • After wiping, make sure the liquid is dried off (wipe all the way to dry).  Do not allow any moisture to sit.
  • Glass cleaner sprayed directly on the fronts is fine.
  • Don’t let cleaner sit between the channels and your glass.